AEROGLAZE K3425A GALLON: Part A Primer Base

AEROGLAZE K3425A GALLON is the liquid base for the K3425 sandable primer/surfacer. This listing covers Aeroglaze K3425 Part A in a 1-gallon can, under product code Z/3001419. The base requires the matching K3425B curative to form the two-component primer system. It is not a ready-to-apply primer or a complete A+B kit.

Is K3425 Right for the Surface?

Start by identifying what the coating will actually contact. A bare metal surface and a metal surface that already has a suitable primer are different application cases, even when the underlying component is the same.

If a work order says only “primer for metal,” check whether it calls for a coating directly on the substrate or a surfacer over an existing primer. That distinction should be resolved before ordering the K3425A primer base.

Match the Base With the Specified Curative

The matching component is AEROGLAZE K3425B PINT, code Z/3001422. If your materials list calls for the complete system, request Part A and Part B as separate line items. Do not select a curative solely because it carries the Aeroglaze name or comes in the same pack size.

The SOCOMORE K3425 Technical Data Sheet provides the mixing and application information. The gallon and pint designations identify the cans; they should not be used to infer the mixing ratio.

Two Timings to Check Before Scheduling the Job

SOCOMORE publishes the following figures for the mixed K3425 system at 25°C and 50% relative humidity:

Neither figure describes Part A on its own. Time to a sandable condition is also not a full-cure time or permission to sand without a safety review. Check the applicable K3425A Safety Data Sheet, the Part B SDS and your site procedure before handling, application or sanding.

Frequently Asked Questions

• Can K3425A be used without Part B?

No. K3425A is the base component. The manufacturer specifies K3425B as the matching curative for the K3425 system.

• Does “GALLON” mean a full gallon of liquid?

It identifies the can size. The manufacturer’s TDS lists the Part A gallon can as 90% full. If net quantity is specified on your purchase order, confirm it against the pack label or supply documentation.

• What should I provide if the coating procedure names a specific substrate or specification?

Include the substrate, any existing primer and the required specification or revision in your enquiry. This gives RIO Middle East the information needed to identify the requested configuration and documentation without assuming compatibility from the product name alone.

Request a Quote From RIO Middle East

Use Add to Quote and specify Z/3001419, the number of Part A cans required, whether you also need K3425B, and any technical or safety documents required for the job. If the work calls for a different coating system, browse RIO Middle East’s Primers category.